How to Bind the T16D Transmitter with the EWRF Long-range Module and Receiver

1. Install the RF module onto the T16D transmitter. Power on both the T16D and the receiver (connect the receiver to the flight controller’s TELEM port, then power on the flight controller).
2. On the T16D transmitter, go to Menu → Receiver Settings → RF Protocol, and set Module Select to External.
3. Select the protocol and baud rate for your RF module (refer to the module manual for details). For an ATA ELRS RF module, select ELRS as the protocol and use the default 400K baud rate. Then enter Parameter Settings.
4. Wait for the transmitter to read the RF module parameters.

Transmitter reading RF module parameters...

Parameters read successfully.

Note: If the RF module and receiver are unbound, a "-" will show in the upper-right corner of the parameter screen.

1. Put the receiver into binding mode: Power the receiver off and on three times in a row (the receiver LED will double‑flash).
2. On the current transmitter screen, short‑press Bind to start binding.
3. Binding successful: The "-" in the upper‑right corner changes to "C". After returning, a signal icon appears at the top of the transmitter, and the RF receiver LED stays solid on.
4. If binding fails: Repeat steps 5 and 6.